Mixer; 7.5 H.P.,1750 rpm,230/460 V

MIXER<br />
Brand: MIX MOR<br />
"V" Belt driven, side entering mixer to be constructed as follows:<br />
Motor: Mixer will be driven by a 7.5 H.P. motor, 1750 R.P.M.<br />
TEFC enclosure, Energy Efficient<br />
Severe Duty for operation on 230/460 volts A.C<br />
three phase, 60 hertz.<br />
V-Belt Drive: Mixer will be complete with heat resistant<br />
Static free, V-belts, sheaves and belt guard<br />
Final output speed will be 420 R.P.M<br />
with a minimum service factor of 1.25<br />
based on motor horsepower.<br />
Mixer Shaft: Shaft will be 2.00” diameter, by 26” long<br />
as measured from the flange facing, constructed of carbon steel.<br />
Mounting Flange: Mixer will mount on an 8”-150# A.N.S.I<br />
forged steel, raised face flange with the bolt holes straddling the vertical centerline<br />
The flange will have a carbon steel facing.<br />
Shaft Seal: Integrally fabricated in the flange will be a Chesterton S10 <br />
single outside mechanical seal with Carbon vsSilicon Carbide seal faces<br />
Viton elastomers and 316 stainless steel metallic components<br />
This seal is rated to 150 psig maximum @ 350F<br />
The seal is designed so that it may be replaced under <br />
a full head of liquid without draining the tank contents.<br />
Impeller: Mixer will be furnished with a 22” diameter<br />
three bladed, FM3<br />
FloMor high efficiency, foil impeller constructed of carbon Steel<br />
The blades will be welded to the hub.<br />
Support: Tie rods and turnbuckles will be supplied for supporting <br />
the mixer to the tank wall.<br />
Torque: 1,131 lb. - in.<br />
Design Bending Moment: 1,527 lb. - in.